Out Of This World Cabinet Pull Installation

With a full cabinet that has two doors the finger pulls will be so closely installed to the corners of the doors that from far away itll look like theres one long piece of hardware adjoining the two doors.

Cabinet pull installation. If your cabinets have slab doors without stiles cabinet pulls are usually 2 to 3 inches up from the bottom edge of the door. Install the first knob drilled to validate location and accuracy. Weve freshened up our kitchen with new cabinets.

Careful measuring and drilling are necessary to ensure your handles knobs or other hardware are installed correctly and evenly without damaging your cabinet doors. So instead of spending hours with a tape measure pencil and combination square marking out knobs and handles youll want to use a cabinet hardware jig. G Johns Sons Ltd - architectural ironmongers based in London.

Or e-mail licensingcabinet-officexgsigovuk This is a value added publication which falls outside the scope of the Core Click-Use Licence. Most cabinet installations involve drilling and installing cabinet knobs or handles. Because as youll see in this article there are a number of screws for installing cabinets that are made specifically for the job.

For lower cabinets it will be the opposite the top screw will be about 2 12 3 from the corner. Determine the distance you want the pulls to be from the corner of the door front. Then center it horizontally on the door frame.

Printed in Great Britain on paper containing at. Using the horizontal rail of the door frame place your screw hole or orient the bottom end of the handle. Measure and mark this location with a pencil.

Ensure accurate hole placement from door to door. Anywhere within this range will work as it is based on personal preference. Place the bottom hardware hole 2 12 to 3 from the bottom of the door front.